Section 18: BODY
PA1562
46
Using a triangular nozzle, apply “Simson” glue
(685126) onto support structure.
Rear baggage compartment without WCL.
Rear baggage compartment equipped with WCL
Carefully install panel onto support structure.
Evenly distribute and install conforming weights
(6 to 8) (80 to 100 lbs total) onto panel for at
least 4 hours. Make sure panel does not move.
Finishing Joints
In the case of lateral finishing joint, apply some
masking tape ¼“ from panel edge and ¼” above
panel.
In the case of front finishing joint, apply some
masking tape on each side of joint.
Clean with anti-silicone the area where the
Simson glue will be applied.
To Next Page
Loading...
