Section 18: BODY
PA1562
66
4. Use chamfer knife. Be careful not to overcut or to cut to the side to prevent damaging
“Tarabus” covering.
5. Add (about 6 inches) some length to the required length of filler bead to make the joint then cut.
6. Take position with welding torch. The proper position is with a slight slope to the rear.
7. Once the welding torch is ready, insert the filler bead into the nozzle and immediately start welding.
Move in a regular manner while pressing slightly with torch.
8. The heel of the fast nozzle must not lean against “Tarabus” covering (always parallel to the surface).
To Next Page
Loading...
