16
Manual No. 7018081-02, Rel. Jun. 1999
REMOVAL and INSTALLATION
© Copyright Isringhausen 1999
MODEL 6800/338 BUS
MODEL 6800/338 PREMIUM LX
Air spring
Set up
• Seat must be removed from
vehicle
• Seat cushion must be removed
from seat (see Cushion seat
pan)
Removal
• Mark and disconnect air line
• Remove top and bottom
mounting fasteners
• Remove air spring
Installation
• Put air spring in place
• Install top and bottom mounting
fasteners
• Connect air line
torque to
44.2 - 62 lb in
(5 - 7 N•m)
do not over tighten
Boot, Boot adapter plate,
ICP bar, and tethers
Set up
• Vehicle must be in a safe parked
position or seat removed from vehicle
• Horizontal adjustment must be
removed (see Horizontal
adjustment)
Removal
• Remove belts from ICP bar
• Remove boot fasteners, remove
boot, and boot adapter plate
• Remove fasteners, tether plate,
tether brackets, tethers, and ICP
bar
Installation
• Install fasteners, tether plate,
tether brackets, tethers, and
ICP bar
• Install boot adapter plate, boot, and
fasteners
• Install belts to ICP bar
torque to
14.8 - 18.4 lb ft
(20 - 25 N•m)
To Next Page
Loading...
