Section 23: ACCESSORIES
PA1562
10
FIGURE 17: SCENIC VIEW CAMERA
1.14 ROOF ANTENNA INSTALLATION
1. Find the desire location and drill a hole
according to specification.
2. To remove dirt and grease, wash hole edge
with alcohol.
3. If so equipped, remove foam padding ring
from antenna to free the metal surface
(foam can produce air bulbs in new rubber
seal).
4. With SIKA 205, wash the opening edge and
the antenna base surface, wait at least two
(2) minutes for chemical evaporation.
5. Apply new seal SIKA 221 on both, vehicle
hole edge and antenna base.
6. Fix the antenna in place.
7. Remove excess seal and complete a
finishing joint all around the antenna base.
2. BACK-UP CAMERA AND MONITOR
An optional back-up camera is available which
provides the driver with visual assistance when
backing-up. The camera is automatically
activated when the transmission is put in
reverse gear and the ignition switch is "ON".
BUTTON DESCRIPTION
1) STANDBY: On/Off switch
2) UP: This key has 3 functions
• Increase of the volume during normal
operation;
• Modification of the setting within a function
e.g. contrast (after calling up the menu);
• By pressing this key when putting in the
reverse gear, the distance markings move
upwards;
3) DOWN: This key has 3 functions
• Decrease of the volume during normal
operation;
• Modification of the setting within a function
e.g. contrast (after calling up the menu);
• By pressing this key when putting in the
reverse gear, the distance markings move
downwards;
4) SELECT: This key has 3 functions
• Selection of the video sources (CA1¼ CA2
¼ AV ¼ CA1). Press less than 1.5 seconds;
• Selection of the functions e.g. picture setting
(after calling up the menu);
• Deleting and calling OSD letters of title &
time (press longer than 1.5 seconds) during
normal operation;
To Next Page
Loading...
