Section 23: ACCESSORIES
PA1562
24
3. When the final position is found, tighten the
wiper arm nuts to 22 Ft-lbs (30 Nm). Wait 30
minutes and tighten again to 22 Ft-lbs.
FIGURE 37: DRIVING MECHANISM (DRIVER SIDE) 23284
4. Lower the protective cover.
5. Connect the windshield washer tubing at the
base of the wiper arm.
6. Check the adjustment on a wet windshield.
FIGURE 38: DRIVING MECHANISM (MOTOR SIDE) 23285
9.3 WINDSHIELD WIPER MOTOR
9.3.1 Windshield Wiper Motor Replacement
The windshield wiper motor is located at lower
front of the vehicle, behind the defroster panel.
Refer to figure 34 for motor location.
WARNING
Park vehicle safely, apply parking brake, stop
engine and set battery master switch to the
‘’OFF’’ position prior to working on the vehicle.
1. Remove the Phillips-head screws retaining
the defroster panels, and remove panels.
2. Disconnect wiring connector from the
windshield wiper motor.
3. Loosen clamping screw retaining the lever at
the end of the motor driving shaft.
4. Remove the three bolts holding the motor to
the steel plate.
5. Remove the windshield wiper motor
(Prévost #800328), reverse removal
procedure to reinstall.
To Next Page
Loading...
