Section 23: ACCESSORIES
PA1562
25
FIGURE 39: WIPER ARMS POSITIONING 23253
9.4 TROUBLESHOOTING
SYMPTOM PROBABLE CAUSE REMEDY
FAIL TO SPRAY WASHER
FLUID
A. Reservoir empty.
B. If below 32°F (0°C), improper
washer fluid frozen.
C. Contamination in tubing or
nozzles.
D. Tubing damage.
E. Tubing bent (kinked) or off one
or more connections.
A. Add proper fluid.
B. Store coach or parts in heated
area, then purge system with low-
temperature solution.
C. Remove with compressed air, if
severely clogged, replace items.
D. Replace section.
E. Realign tubing and/or refit. Trim
end to ensure proper fit or replace.
INADEQUATE SPRAYING
A. Tubing failure. A. Replace tubing.
SLOW OPERATION
A. Improper solution.
B. Jet stream improperly directed.
C. Check if valve is stuck in the
open position.
A. Replace with proper type solution.
B. Reposition nozzles.
C. Remove, clean or replace.
To Next Page
Loading...
