Section 23: ACCESSORIES
PA1562
28
Install sensor onto valve. Torx screw T-
20. Torque to 35lb-in (4Nm) (supplier
specification for the screw).
Make sure sensor rests against rim
flange.
IMPORTANT
Use the screw only once. This screw
uses a thread lock. Replacement screw
#651084.
Note bar code and tie it up using wheel
holes. Use supplied removable tie-rap.
Decal
Glue decal facing the valve.
#651091 ENGLISH #651090 BILINGUAL
11. AUTOMATIC FIRE SUPPRESSION
SYSTEM (AFSS) (OPTIONAL
This optional system is used to shut down the
engine and to extinguish a fire in the engine
compartment or in the vicinity of the preheating
system if so equipped.
The system operation is fully automatic and
does not require assistance from the operator,
however if required, the system can be manually
activated by the operator at any time.
Refer to Prevost Operator’s Manual for system
operation and operational sequence (fire).
If more information is needed on the system,
please refer to Kidde Dual Spectrum “Operation
& Maintenance Manual annexed at the end of
this section.
11.1 PERIODIC MAINTENANCE
PRE-TRIP
o Verify that the Protection Panel ”SYSTEM
OK” lamp is on solid green.
EVERY 3000 MILES OR MONTHLY (whichever
comes first)
General
o Verify that neither the protected equipment
nor the hazard has changed.
o Verify that no obvious physical damage or
condition exists that might prevent system
operation.
To Next Page
Loading...
