Page No.12
Manual No. NDS8
Spicer Speciality Axle Division - Technical Publications
© Spicer Speciality Axle Division
OVERHAUL PROCEDURES
HUB END REASSEMBLY CONTINUED
23. Refit ABS sensor bush and sensor into
swivel
NOTE:-
A NEW SENSOR BUSH SHOULD BE
FITTED WHENEVER A NEW SENSOR IS
FITTED.
IF FITTING A NEW SENSOR AND BUSH
INTO AN ABS READY AXLE. SENSOR
AND BUSH SHOULD BE SUPPLIED
FROM THE SAME MANUFACTURER.
24. Push sensor through bush until it comes into
contact with polewheel on hub assembly.
25. Rotate hub bearing assembly through at
least one revolution.
THIS SERVES TO SET THE CORRECT
GAP BETWEEN SENSOR AND
POLEWHEEL.
Refit ABS sensor bush
and sensor into swivel
To Next Page
Loading...
