PREVOST X3-45 Multiplex User Manual

7 Appendix III — Additional ABS Information
49
Meritor WABCO Maintenance Manual MM-0112 (Revised 07-05)
Reconfiguration Procedure
How to Reconfigure an ECU (E Version)
E version ECUs memorize the following components if they are
connected at power-up:
앫 ATC valve
앫 Retarder relay
앫 Datalink SAE J1939
NOTE: The ATC valve and Datalink SAE J1939 are required
for
RSC. The RSC ECUs cannot be reconfigured to remove these
components. Only the retarder relay is memorized or cleared.
Once these components have been memorized, the ECU will look for
them at each power-up. If a memorized component is not present,
the ECU will record a fault. For example, if an ATC valve is
memorized, but is not present at the next power-up, the ECU
records a fault. This can occur if an ECU is moved from one truck to
another and one or more of the memorized components are not
available on the new truck. If this occurs, use TOOLBOX™ Software
to reconfigure the ECU. If you do not have TOOLBOX™ Software,
follow the manual reconfiguration instructions in this section.
TOOLBOX™ Software
NOTE: For complete instructions for using TOOLBOX™ Software,
refer to the TOOLBOX™ User’s Manual, TP-99102.
To reconfigure the ECU with TOOLBOX™ Software, use the Reset
Memorized command.
Select Reset Memorized from the pull down menu to tell the ECU
to reset the memorized or “learned” components. Figure 7.1 and
Figure 7.2.
Figure 7.1
Figure 7.2
Before reconfiguring the ECU, contact ArvinMeritor’s Customer
Service Center at 800-535-5560 for additional information.
Figure 7.1
Figure 7.2
4004034a
4004035a

PREVOST X3-45 Multiplex Specifications

General

Length	45 ft
Width	102 in
Engine	Volvo D13
Horsepower	500 hp
GVWR	54, 000 lbs
Height	146 in
Sleeping Capacity	Varies based on floor plan
Water Capacity	Varies based on floor plan