Servicing Work
Shifting
Axle stop
20 Instructions on Design, Operation, Maintenance and Inspection
Fig. 13 I
nitial position
Sliding bushes not yet
adjusted
5.2.1 Operating mode of the automatically adjusting steering limitation
In the end positions, the valve piston tappets run up against the sliding bushes (20 and 128,
respectively) and open the steering limiter valves (U and T, respectively).
The opening of the steering limiter valve is determined by the position of the sliding bushes on
the screws (20 and 128).
5.2.2 Setting
Note:
This setting (Fig. 14) can only be carried out after the steering gear was fitted to the vehicle. To
enable the setting, the steering linkage and the axle stops must be installed and set.
Fig. 14 Setting operation
Positioning of the
sliding bushes
For vehicles with a rigid axle:
Relieve the steered axle by jacking it up (there must, however, still be a load on the steered axle)
or place it on swivel plates. ¡
¡ see vehicle manufacturer’s instructions
To Next Page
Loading...