PREVOST X3-45 Multiplex User Manual

Removal and Re-Installation of the Steering Gear
Instructions on Design, Operation, Maintenance and Inspection
31
2.14 Connect the pressure and return lines between the pump, the steering gear and the steering
cyl
inder according to the notes taken on the removal.
Fill the steering system with oil and bleed it.
See Chapter III.
2.15 Set the hydraulic steering limitation
See Chapter III.
2.16 Check the oil level
Before pulling out the oil dipstick, thoroughly clean the oil tank and its immediate vicinity to prevent
dirt from getting into the hydraulic fluid.
Attention:
If the oil level is too low, it can entail malfunctions which, in turn, may cause a failure of the
hydraulic steering assistance.
Additionally, for vehicles equipped with a ZF Servocom RAS (rear axle steering system):
Check the oil level in the straight ahead driving position.
If the oil level is above the upper mark, there may be a leakage in the master cylinder of the ZF
Servocom RAS.

PREVOST X3-45 Multiplex Specifications

General

Length	45 ft
Width	102 in
Engine	Volvo D13
Horsepower	500 hp
GVWR	54, 000 lbs
Height	146 in
Sleeping Capacity	Varies based on floor plan
Water Capacity	Varies based on floor plan