15. Install a new o-ring (11) on the top plate without
allowing it to roll. Seat it at the top of the groove.
Install o-ring
14. Install the backup ring (12) on the top plate. Seat it
at the bottom of the groove.
Install backup ring
17. Grease the sealing areas of the housing (1).Grease housing
sealing areas
18. Place the spring (10) on the top plate (13).Position spring
16. Grease the o-ring (11) and back-up ring (12).Grease o-ring and
back-up ring
The housing may have sharp
edges. Be careful not to cut your
finger when applying grease.
CAUTION
!
To Next Page
Loading...