PREVOST X3-45 Multiplex User Manual

Section 16 : SUSPENSION
PA1562
18
1. Drag Link Ends: Lubricate at two fittings,
one at each end of link, every 6,250 miles
(10 000 km) with good quality lithium-base
grease NLGI No. 2 (Shell Retinax LX or
equivalent).
2. Relay Rod Ends: Lubricate at two fittings,
one at each end of rod, every 6,250 miles
(10 000 km) with good quality lithium-base
grease NLGI No. 2 (Shell Retinax LX or
equivalent).
3. Tie Rod Ends: Lubricate at four fittings, one
at each end of both tie rods, every 6,250
miles (10 000 km) with good quality lithium-
base grease NLGI No. 2 (Shell Retinax LX
or equivalent).
4. Swivel Assembly: Refer to DANA SPICER
MAINTENANCE MANUAL NDS AXLES
Lubrication and Maintenance" annexed at
the end of Section 10.
5. Idler Arm and Crank bell: Lubricate at two
fittings, one on the idler arm and the other
on the crank bell, every 6,250 miles (10 000
km) with good quality lithium-base grease
NLGI No. 2 (Shell Retinax LX or equivalent).
Apply grease gun pressure to the fitting until
lubricant appears at the top seal.
6. Upper A-Arm Central Ball Joint: Lubricate
at fitting until you see some grease on the
relief valve nearby, every 6,250 miles (10
000 km) with good quality lithium-base
grease NLGI No. 2 (Shell Retinax LX or
equivalent).
FIGURE 22: LUBRICATION FITTINGS' LOCATION DIAGRAM 16119

PREVOST X3-45 Multiplex Specifications

General

Length	45 ft
Width	102 in
Engine	Volvo D13
Horsepower	500 hp
GVWR	54, 000 lbs
Height	146 in
Sleeping Capacity	Varies based on floor plan
Water Capacity	Varies based on floor plan