QL-30/60 User Guide 111
14
Diagnostic Functions
The Diagnostics menu contains several functions for troubleshooting.
ASCII Dump Mode
ASCII Dump Mode offers the option of checking incoming control sequences at an interface.
The commands are printed out as text. In addition, a corresponding error message is printed
out immediately after an error occurs.
The printout occurs using the heat level and print speed specified in the Setup > Printing menu.
Note: The printout occurs without taking the label gaps into consideration. This is why
continuous media is most suitable for this purpose.
Note: In case of questions about programming, keep a printout of your label file which was
created in ASCII Dump Mode handy. The printout can be transmitted clearly via fax.
1) Insert printable medium (labels, continuous media) which extends across the entire printing
width.
2) If the printout is to occur using thermal transfer printing, insert transfer ribbon with the
maximum width.
3) Start menu.
4) Select Diagnostics > ASCII Dump Mode.
5) Send print jobs.
6) Select to cancel the printout or switch to the Ready mode.
To Next Page
Loading...
Need help?
General
