Extras
QL-30/60 User Guide 121
Reset Passwords
The function Reset passwords allows you to reset all passwords for the network services to the
default values.
1) Start menu.
2) Select Extras.
If the menu is protected via a PIN, a prompt appears in the display. Enter the code number
and confirm it.
3) Select Reset passwords.
The display shows “Reset passwords”.
4) Select Continue. The passwords will be reset and printer returns to the Extras menu.
Cleaning Interval
With the parameter Cleaning interval an interval for the printhead cleaning can be set in steps
of 100 m media passage.
If the set length of the medium (label strip, transfer ribbon) has passed the printhead and an
error occurs in the flow of the medium (e.g. label end, transfer ribbon end), the Clean printhead!
message appears in the display.
The error message for the error which occurred is not displayed until the Clean printhead!
message is acknowledged. As long as no errors occur in the medium flow, no messages are
displayed and the print job is continued even if the cleaning interval has passed.
1) Start menu.
2) Select Extras.
If the menu is protected via a PIN, a prompt appears in the display. Enter the code number
and confirm it.
Table 42: Default passwords
Function User name Password
Web interface access admin admin
FTP printing ftpprint print
FTP access to storage
devices
ftpcard card
FTP firmware update ftpadmin admin
Web service soap soap
To Next Page
Loading...
Need help?
General
