Storage Devices
146 QL-30/60 User Guide
Writing
The storage devices can be written to in several ways. The most functionally secure way is
writing to the storage device via a data interface.
Note: The device selected as Default storage is written to by default. To write to another device
specify the path name of the device in the file name (see Programming Manual).
Example
With direct programming, the command sequence for saving a label (file XYZ) has the following
form:
Ms LBL; XYZ Command for saving the file XYZ
J |
H 100,0,T |
S l1;0,0,68,71,104 | Contents of the file XYZ
T 10,10,0,3,pt15;memory card |
A 1[NOPRINT] |
Ms LBL End of save command
• After transfer of the command sequence, the file XYZ is saved with the commands from J
to A.
• Only one label is printed each time the file XYZ is called up.
• The [NOPRINT] parameter in command A suppresses the printing of a label when the file
is saved.
• To print the label a variable number of times, use command A [?].
Storage Device Functions
Load Label
Labels whose descriptions are saved on the storage device can be printed using the Load label
function.
1) Start menu.
2) Select Storage > Load label.
The display shows the selection of external storage devices and the label files stored on
the devices.
3) Select a label and confirm.
If a label is selected which was saved with a fixed contents and fixed label quantity, the print
job is started immediately.
To Next Page
Loading...
Need help?
General
