QuickLabel QL-60 - Cutting on Demand with Cutter CU400

I/O Interface
QL-30/60 User Guide 139
Cutting on Demand with Cutter CU400
In the standard cut mode all labels of a print job will be printed and cut one after another without
interruption. Using the I/O interface the print job can be split into single steps with printing and
cutting each one label.
Requirements:
• Operation with Cutter CU400.
• External circuit as shown in Figure 57 / Figure 58
• Setting Printing > Print on Demand = “On”.
Operation:
1) Send a print job.
2) Activate START.
The first label will be printed and cut.