Diagnostic Functions
114 QL-30/60 User Guide
Event Log
The label printer saves the following events in the Event log:
• Hardware fault
• Printhead replacement
• Firmware updates
• Changing the OEM name
• Resetting of the service counters
The printout occurs using the heat level and print speed specified in the Setup > Printing menu.
Note: The printout occurs without taking the label gaps into consideration. This is why
continuous media is most suitable for this purpose.
1) Insert printable medium (labels, continuous media) which extends across the entire printing
width.
2) If the printout is to occur using thermal transfer printing, insert transfer ribbon with the
maximum width.
3) Start menu.
Table 41: Information in Label profile
# Description
1 Date and time of the printout
Device type
Version and creation date of the firmware
Serial number of the PCB CPU
Firmware version and serial number of the label sensor
2 Coordinate in the direction of media flow at which the label start was
detected
3 Type of peripheral device connected
4 Print speed, method of label detection (Gap sensor / Bottom-reflect
sensor)
Brightness of the sensor LED during the measurement
5 Average value and variation of label distances
To Next Page
Loading...
