Configuration
QL-30/60 User Guide 91
Errors
• Start menu.
• Select Setup > Errors.
REPRINT mode Configuration of the I/O signal REPRINT
• Edge: A label will be repeated by
switching on 24V between REPRINT
and GND_EXT.
• Level: A label will be repeated as long
as 24V are switched on between
REPRINT and GND_EXT.
• START/REPRINT select: A label will
be repeated when 24V are switched
on between REPEAT and GND_EXT
and the START signal will be
activated additionally.
Edge
Automatic
LBLREM
Simulation of the I/O signal LBLREM
For peel-off mode without present
sensor
• On: With the signal START the
removing of the previous label also
will be confirmed.
• Off: To confirm the label removing the
signal LBLREM must be activated.
Off
Table 32: Parameters of the Setup > Errors menu
Icon Parameter Meaning Default
Error-Reprint
• On: With a correctable error and
corresponding troubleshooting, the
label being printed when the error
occurs is repeated.
• Off: Print job is continued with the next
label.
On
Syntax error Printer switches to error mode after
receipt of an incorrect command.
On
Table 31: Parameters of the Setup > Interfaces > I/O menu (Continued)
Icon Parameter Meaning Default
To Next Page
Loading...
