QL-30/60 User Guide 149
21
Remote Access via VNC
Note: For the remote access via VNC the firmware version 5.03 or later must be installed.
VNC is software that allows remote control of a printer's operation control panel (server) via a
computer (client) through input devices like keyboard and mouse.
VNC is not platform dependent and enables the use of a Windows computer as well as a mobile
Android or iOS system as an external remote control. The prerequisite for this is the installation
of a VNC client on the system used.
Preparing the Computer
1) Install the VNC client on the computer.
Preparing the Printer
1) Activate the VNC server under Setup > Interfaces > Network services > VNC server.
2) Enter password vnc under Security > Password VNC.
For Wireless Access:
1) Activate WLAN under Setup > Interfaces > WLAN > WLAN.
2) Find out the WLAN-IP-Address under Info.
For Ethernet Access:
1) Find out the Ethernet-IP-Address under Info.
Establishing a Connection
1) Start the VNC client on the computer.
2) Enter the IP address and password vnc in the configuration of the VNC client.
3) Activate the connection.
The menu of the printer will be visible and usable via mouse click, keyboard or touch-pad
just like on the printer itself.
To Next Page
Loading...
