Configuration
84 QL-30/60 User Guide
Cutting
Note: If cutter is not installed, access only with service key inserted.
• Start menu.
• Select Setup > Cutting.
Table 23: Parameters of the Setup > Tearing-off menu
Icon Parameter Meaning Default
Tear-off mode Positioning the label medium for tearing
off at the tear-off plate.
• On: Additional advancement of the
label medium which positions the
label gap after the last printed label at
the dispense plate.
• Off: Label advance stops once the last
label has fully passed the print line.
On
Tear-off position Shifting of the tear-off position in the
direction of media flow. With positive
values, the label strip is transported
farther out of the printer.
0.0 mm
Table 24: Parameters of the Setup > Cutting menu
Icon Parameter Meaning Default
Cut position Offset of the cut position relative to the
rear label edge.
The setting can also be adjusted by the
software.
The settings of configuration and
software are added together.
0.0 mm
Perforation level With perforation cutter only
Setting of the perforation depth.
The setting can also be adjusted by the
software.
The settings of configuration and
software are added together.
0
To Next Page
Loading...
Need help?
General
