I/O Interface
QL-30/60 User Guide 133
Peeling-off on Demand without Present Sensor
In the peel-off mode with PS800 or PS900 the label removal from the peel position is detected
by an optical sensor.
Using the I/O interface the label removal can be confirmed by the external signal LBLREM. That
way it is possible to operate the printer in peel-off mode without present sensor.
Starting Print and Confirming Label Removal with Two Signals
Requirements:
• Operation without present sensor.
• External circuit as shown in Figure 51 / Figure 52
• Setting Printing > Print on Demand = “On”.
• Setting Interfaces > I/O > Automatic LBLREM = “Off”
Operation:
1) Send a print job.
2) Activate START.
The first label will be printed an transported to the peel position.
3) Remove the label.
4) Confirm the label removal with signal LBLREM.
To Next Page
Loading...
