Extras
120 QL-30/60 User Guide
6) Confirm the selection. The .xml file will be stored in the folder /misc of the storage device.
An error message appearing during the saving procedure may be caused by an unreadable
medium (e.g. unknown medium, unformatted medium). See “Format Storage” on page 148.
Load Settings
A printer configuration previously saved to a storage device can be loaded with the Load
settings function.
1) Start menu.
2) Select Extras.
If the menu is protected via a PIN, a prompt appears in the display. Enter the code number
and confirm it.
3) Select Load settings.
4) Select the desired file.
5) Confirm the selection. Loading of the configuration data starts. Do not remove the USB
flash drive until the loading procedure is complete. The printer returns to the Extras menu.
If an error occurs during the loading procedure, an error message appears in the display.
Restart the loading procedure in this case. If an error occurs again, the configuration
parameters must be entered via the control panel.
Reset Settings
With the Default settings function all setup parameters except the passwords can be reset to
the default values. See “Security” on page 77.
1) Start menu.
2) Select Extras.
If the menu is protected via a PIN, a prompt appears in the display. Enter the code number
and confirm it.
3) Select Reset settings.
The display shows “Reset settings”.
4) Select Continue. The setup parameters will be reset and the printer returns to the Extras
menu.
To Next Page
Loading...
Need help?
General
