I/O Interface
QL-30/60 User Guide 137
Starting Print and Confirming Label Removal with Signal START
Requirements:
• Operation without present sensor.
• External circuit as shown in Figure 55 / Figure 56
• Setting Printing > Print on Demand = “On”.
• Setting Interfaces > I/O > START mode = “Level”.
• Setting Interfaces > I/O > Automatic LBLREM = “On”.
Operation:
1) Send a print job.
2) Activate START and hold it active.
The first label will be printed an transported to the peel position.
3) Remove the label.
4) Confirm the label removal with deactivation of START.
To Next Page
Loading...
