Radware Alteon - Page 135

Alteon Application Switch Operating System Application Guide
Border Gateway Protocol
Document ID: RDWR-ALOS-V2900_AG1302 135
3. Configure internal peer router 1 and external peer router 2.
4. Configure redistribution for peer 1.
5. Configure aggregation policy control. Configure the routes that you want aggregated.
6. Apply and save the configuration.
>> # /cfg/l3/bgp/peer 1
(Select internal peer router 1)
>> BGP Peer 1# ena
(Enable this peer configuration)
>> BGP Peer 1# addr 10.1.1.4
(Set IP address for peer router 1)
>> BGP Peer 1# ras 135
(Set remote AS number)
>> BGP Peer 1# /cfg/l3/bgp/peer 2
(Select external peer router 2)
>> BGP Peer 2# ena
(Enable this peer configuration)
>> BGP Peer 2# addr 20.20.20.2
(Set IP address for peer router 2)
>> BGP Peer 2# ras 200
(Set remote AS number)
>> # /cfg/l3/bgp/peer 1/redist
(Select redistribute)
>> BGP Peer 1# default redistribute
(Set default to redistribute)
>> BGP Peer 1# fixed ena
(Enable fixed routes)
>> # /cfg/l3/bgp/aggr 1
(Set aggregation number)
>> BGP Aggr 1# addr 135.0.0.0
(Add IP address to aggregate 1)
>> BGP Aggr 1# mask 255.0.0.0
(Add IP mask to aggregate 1)
>> BGP Aggr 1# ena
(Enable route aggregation)
>> # apply
>> # save