Radware Alteon - Page 293

Alteon Application Switch Operating System Application Guide
Load Balancing Special Services
Document ID: RDWR-ALOS-V2900_AG1302 293
Figure 44: Load Balancing RTSP Servers
To configure RTSP load balancing
1. On Alteon, before you start configuring RTSP load balancing:
— Connect each QuickTime server to the Layer 2 switch
— Connect each RealNetworks server to the Layer 2 switch
— Configure the IP addresses on all devices connected to Alteon
— Configure the IP interfaces on Alteon
— Enable Direct Access Mode (DAM)
— Disable Bandwidth Management
— Disable proxy IP addressing
2. Enable SLB.
3. Configure IP addresses for the real servers.
>> # /cfg/slb/on
>> # /cfg/slb/real 1/rip 30.30.30.10/ena
(Define IP address for Real Server 1)
>> # /cfg/slb/real 2/rip 30.30.30.20/ena
(Define IP address for Real Server 2)
>> # /cfg/slb/real 3/rip 30.30.30.30/ena
(Define IP address for Real Server 3)
>> # /cfg/slb/real 4/rip 40.40.40.10/ena
(Define IP address for Real Server 4)
>> # /cfg/slb/real 5/rip 40.40.40.20/ena
(Define IP address for Real Server 5)
>> # /cfg/slb/real 6/rip 40.40.40.30/ena
(Define IP address for Real Server 6)