Radware Alteon User Manual

Alteon Application Switch Operating System Application Guide
Load Balancing Special Services
Document ID: RDWR-ALOS-V2900_AG1302 303
— Configure for RADIUS services 1812, 1813, and 1645.
Note: If the application is not recognized by the port, set the application to basic-slb.
Note: The RADIUS service number specified on Alteon must match with the service specified
on the server.
2. Configure Alteon for basic SLB.
3. Configure IP addresses for the RADIUS/WAP gateways.
4. Create a group to load balance the WAP gateways.
5. Enable the external notification from the WAP gateway to add and delete session requests if you
are using static session via TPCP.
6. Enable TPCP for adding and deleting WAP sessions.
7. Apply and save your configuration.
>> # /cfg/slb/virt <number> /service <name|number> /protocol udp
>> # /cfg/slb/on
>> # /cfg/slb/real 1/rip 1.1.1.100
(Define address for WAP Gateway1)
>> Real server 1# ena
(Enable Real Server 1)
>> # /cfg/slb/real 2/rip 2.2.2.100
(Define address for WAP Gateway 2)
>> Real server 2# ena
(Enable Real Server 2)
>> # /cfg/slb/real 3/rip 3.3.3.100
(Define address for WAP Gateway 3)
>> Real server 3# ena
(Enable Real Server 3)
>> # /cfg/slb/group 100
(Define a group)
>>Real Server Group 100# add 1
(Add Real Server 1)
>>Real Server Group 100# add 2
(Add Real Server 2)
>>Real Server Group 100# add 3
(Add Real Server 3)
>> # cfg/slb/adv/tpcp ena
>> # cfg/slb/wap/tpcp ena
>> WAP Options# apply
>> WAP Options# save

Radware Alteon Specifications

General

Model	Alteon
Manufacturer	Radware
Layer	Layer 4-7
Type	Application Delivery Controller (ADC)
Features	Load balancing, SSL offloading, application acceleration, DDoS protection
Form Factor	Virtual Appliance