Radware Alteon - Page 327

Alteon Application Switch Operating System Application Guide
Load Balancing Special Services
Document ID: RDWR-ALOS-V2900_AG1302 327
Figure 51: SIP Load Balancing Configuration Example
To configure SIP load balancing
1. Before you start configuring SIP load balancing:
— Connect each SIP proxy server to Alteon
— Configure the IP addresses on all devices connected to Alteon
— Configure the IP interfaces on Alteon
— Enable Direct Access Mode (DAM)
— Disable proxy IP addressing
2. Enable server load balancing.
3. Configure IP addresses for the SIP proxy servers.
4. Create a group to load balance the SIP proxy servers.
>> # /cfg/slb/on
>> # /cfg/slb/real 1/rip 10.10.10.1
(Define address for MCS 1)
>> Real server 1# ena
(Enable Real Server 1)
>> # /cfg/slb/real 2/rip 10.10.10.2
(Define address for MCS 2)
>> Real server 2# ena
(Enable Real Server 2)
>> # /cfg/slb/real 3/rip 10.10.10.3
(Define address for MCS 3)
>> Real server 3# ena
(Enable Real Server 3)
>> # /cfg/slb/group 100
(Define a group)
>>Real Server Group 100# add 1
(Add Real Server 1)
>>Real Server Group 100# add 2
(Add Real Server 2)
>>Real Server Group 100# add 3
(Add Real Server 3)