Radware Alteon - Page 654

Alteon Application Switch Operating System Application Guide
WAN Link Load Balancing
654 Document ID: RDWR-ALOS-V2900_AG1302
2. Configure an entry for each ISP and specify the virtual and real server (ISP router).
3. Configure the domain record for xyz.com.
4. Configure an entry for each ISP and specify the virtual and real server (ISP router).
Step 7—Apply and Save Your Changes
You must apply your changes in order for them to take effect, and you must save changes if you
want them to remain in effect after reboot.
1. Apply and verify the configuration.
Examine the resulting information. If any settings are incorrect, make the appropriate changes.
2. Save your new configuration changes.
3. Check the load balancing information.
4. Check that all load balancing parameters are working as expected. If necessary, make any
appropriate configuration changes and then check the information again.
>> Domain record 1# entry 1/ena
(Define entry for ISP 1)
>> Virt Real Mapping virt 1
(Select virtual server 1 for ISP 1)
>> Virt Real Mapping# real 1
(Select real server for ISP 1)
>> Domain record 1# entry 2/ena
(Define entry for ISP 2)
>> Virt Real Mapping# virt 2
(Select virtual server 2 for ISP 2)
>> Virt Real Mapping# real 2
(Select real server for ISP 2)
>> # /cfg/slb/linklb/drecord 2
(Select the domain record menu)
>> Domain Record 2# ena
(Enable the domain)
>> Domain record 2# domain xyz.com
(Define the domain name)
>> Domain record 2# entry 1/ena
(Define entry for ISP 1)
>> Virt Real Mapping# virt 3
(Select virtual server 3 for ISP 1)
>> Virt Real Mapping# real 1
(Select real server for ISP 1)
>> Domain record 1# entry 2/ena
(Define entry for ISP 2)
>> Virt Real Mapping# virt 4
(Select virtual server 4 for ISP 2)
>> Virt Real Mapping# real 1
(Select real server for ISP 2)
>> Layer 4# apply
>> Layer 4# cur
>> Layer 4# save
>> Layer 4# /info/slb/dump