Radware Alteon - Page 695

Alteon Application Switch Operating System Application Guide
Virtual Private Network Load Balancing
Document ID: RDWR-ALOS-V2900_AG1302 695
6. Configure VRRP for Virtual Routers 1 and 2.
7. Enable SLB on the clean Alteon CA.
>> IP Static Route# add 10.0.0.20
(Enter destination IP address)
>> IP Static Route# 255.255.255.255
(Destination subnet mask)
>> IP Static Route# 20.0.0.101
(Enter gateway IP address)
>> IP Static Route# 2
(For Interface 2)
>> IP Static Route# add 10.0.0.21
(Static route destination IP
address)
>> IP Static Route# 255.155.255255
(Destination subnet mask)
>> IP Static Route# 20.0.0.102
(Enter gateway IP address)
>> IP Static Route# 3
(For Interface 3)
>> # /cfg/l3/vrrp/on
(Enable VRRP)
>> Virtual Router Redundancy Protocol# vr 1
(Select Virtual Router 1 menu)
>> VRRP Virtual Router 1# ena
(Enable the virtual router)
>> VRRP Virtual Router 1# vrid 1
(Assign Virtual Router ID 1)
>> VRRP Virtual Router 1# if 1
(To Interface Number 1)
>> VRRP Virtual Router 1# prio 101
(Set the renter priority)
>> VRRP Virtual Router 1# addr 30.0.0.50
(Set IP address of virtual router)
>> VRRP Virtual Router 1# share dis
(Disable sharing)
>> VRRP Virtual Router 1# track
(Select Virtual Router Tracking
menu)
>> VRRP VR 1 Priority Tracking# vrs ena
(Enable tracking of virtual routers)
>> VRRP VR 1 Priority Tracking# apply
(Apply the configuration)
>> VRRP VR 1 Priority Tracking# save
(Save the configuration)
>> VRRP VR 1 Priority Tracking# /cfg/l3/vrrp/vr 2
Select Virtual Router 2 menu)
>> VRRP Virtual Router 2# ena
(Enable the virtual router)
>> VRRP Virtual Router 2# vrid 2
(Assign virtual router ID 2)
>> VRRP Virtual Router 2# if 2
(To Interface Number 2)
>> VRRP Virtual Router 2# prio 101
(Set the renter priority)
>> VRRP Virtual Router 2# addr 20.0.0.1
(Set IP address of virtual router)
>> VRRP Virtual Router 2# share dis
(Disable sharing)
>> VRRP Virtual Router 2# track
(Select the Virtual Router Tracking
menu)
>> VRRP VR 2 Priority Tracking# ports ena
(Track VLAN ports)
>> VRRP VR 2 Priority Tracking# apply
(Apply the configuration)
>> VRRP VR 2 Priority Tracking# save
(Save the configuration)
>> # /cfg/slb/on