Alteon Application Switch Operating System Application Guide
Bandwidth Management
Document ID: RDWR-ALOS-V2900_AG1302 777
• Policy 2 is for broadband customers with higher bandwidth allocation needs.
1. Select the first bandwidth policy for dialup customers. Each policy must have a number from 1
to 512. Ensure BWM is enabled on Alteon (
/cfg/bwm/on).
2. Set the hard, soft, and reserved rate limits for the bandwidth policy, in Mbps.
3. On Alteon, select a BWM contract and name the contract. Each contract must have a unique
number from 1 to 1024.
4. Set the bandwidth policy for this contract. Each BWM contract must be assigned a bandwidth
policy.
5. Enable this BWM contract.
6. Select the second bandwidth policy for broadband customers.
7. Set the hard, soft, and reserved rate limits for this policy, in Mbps.
8. On Alteon, select the second BWM contract and name the contract.
9. Set the bandwidth policy for this contract. Each BWM contract must be assigned a bandwidth
policy.
10. Enable this BWM contract.
11. On Alteon, apply and verify the configuration.
>> # /cfg/bwm/pol 1
>> Policy 1# hard 5
>> Policy 1# soft 4
>> Policy 1# resv 3
(Set "never exceed" rate)
(Set desired bandwidth rate)
(Set committed information rate)
>> Policy 1# /cfg/bwm/cont 1
>> BWM Contract 1# name dial-up
>> BWM Contract 1# pol 1
>> BWM Contract 1# ena
>> BWM Contract 1# /cfg/bwm/pol 2
>> Policy 2# hard 30
>> Policy 2# soft 25
>> Policy 2# resv 20
(Set "never exceed" rate)
(Set desired bandwidth rate)
(Set committed information rate)
>> Policy 2# /cfg/bwm/cont 2
>> BWM Contract 2# name broadband
>> BWM Contract 2# pol 2
>> BWM Contract 2# ena
To Next Page
Loading...
