Alteon Application Switch Operating System Application Guide
Content-Intelligent Server Load Balancing Not Using Layer 7 Content Switching Rules
810 Document ID: RDWR-ALOS-V2900_AG1302
Figure 137: Requests with ".cgi" in the URL
Configuring URL-Based Server Load Balancing
To configure URL-based SLB
1. Before you can configure SLB string-based load balancing, ensure that Alteon has already been
configured for basic SLB with the following tasks:
Note: When URL-based SLB is used in an active/active redundant setup, use a proxy IP
address instead of Direct Access Mode (DAM) to enable the URL parsing feature.
— Assign an IP address to each of the real servers in the server pool.
— Define an IP interface.
— Define each real server.
— Define a real server group and set up health checks for the group.
— Define a virtual server on virtual port 80 (HTTP), and assign the real server group to service
it.
— Enable SLB.
— Enable client processing on the port connected to the clients.
For information on how to configure your network for SLB, see Server Load Balancing, page 165
.
To Next Page
Loading...
Need help?
General