Radware Alteon - Page 812

Alteon Application Switch Operating System Application Guide
Content-Intelligent Server Load Balancing Not Using Layer 7 Content Switching Rules
812 Document ID: RDWR-ALOS-V2900_AG1302
• /index.shtm
3. Apply and save your configuration changes.
4. Identify the defined string IDs.
For easy configuration and identification, each defined string is assigned an ID number, as
shown below:
5. Configure one or more real servers to support URL-based load balancing.
Add the defined strings to the real server, where ID is the identification number of the defined
string.
Note: If you do not add a defined string (or add the defined string any) the server handles any
request.
A server can have multiple defined strings such as:
— /images
— /sales
— .gif
With these defined strings, this particular server can handle requests that start with
/images or
/sales and any requests that contain .gif.
6. Enable SLB.
7. Enable DAM or configure proxy IP addresses and enable proxy on the client port.
DAM and proxy IPs allow you to perform port mapping for URL load balancing.
— Enable DAM
— Configure a proxy IP address and enable proxy on the client port.
>> # /cfg/slb/layer7/slb/cur
ID SLB String
1any
2.gif
3/sales
4/xitami
5 /manual
6.jpg
>> # /cfg/slb/real 2/layer7/addlb <ID>
>> # /cfg/slb/on
>> # /cfg/slb/adv/direct ena
>> # /cfg/slb/direct dis
>> # /cfg/slb/pip