Renesas H8 Series Hardware Manual

Section 6 ROM
Rev. 7.00 Mar 10, 2005 page 161 of 652
REJ09B0042-0700
6.6.2 Flash Memory Control Register 2 (FLMCR2)
Bit 76543210
FLER———————
Initial value 0 0 0 0 0 0 0 0
Read/Write R — — — — — — —
FLMCR2 is a register that displays the state of flash memory programming/erasing. FLMCR2 is a
read-only register, and should not be written to.
Bit 7—Flash Memory Error (FLER)
This bit is set when the flash memory detects an error and goes to the error-protection state during
programming or erasing to the flash memory. See section 6.9.3, Error Protection, for details.
Bit 7
FLER Description
0 The flash memory operates normally. (initial value)
1 Indicates that an error has occurred during an operation on flash memory
(programming or erasing).
Bits 6 to 0—Reserved
These bits are always read as 0 and cannot be modified.

Renesas H8 Series Specifications

General

Brand	Renesas
Model	H8 Series
Category	Computer Hardware
Language	English