GX-6000 Operator’s Manual Using Maintenance Mode • 154
2 . Press and release POWER/ENTER. The current Auto Cal setting will
begin to flash.
3 . Use ▲AIR or SHIFT ▼ (PANIC) to display the desired setting.
4 . Press and release POWER/ENTER to save the setting. The setting will
stop flashing.
Returning to the BUMP SETTINGS Menu
1 . From the BUMP PARAMETERS screen, place the cursor next to
ESCAPE.
2 . Press and release POWER/ENTER. The instrument will return to the
BUMP SETTING screen.
Updating the Bump Reminder Setting
With BUMP REMINDER set to ON, the GX-6000 will give an indication at
start up if it is due for bump testing. The type of indication will depend on the
BUMP EXPRD setting (see “Updating the Bump Expired Setting” on
page 155).
NOTE: If BUMP REMINDER is set to ON but BUMP DISP is set to
OFF, the instrument will alert you if a bump test is due but the bump
test item will not appear in Calibration Mode.
With BUMP REMINDER set to OFF (factory setting), the GX-6000 will
not give an indication at start up if it is due for bump testing.
1 . From the BUMP SETTING screen, place the cursor next to BUMP
REMINDER.
2 . Press and release POWER/ENTER. The current Bump Reminder setting
will be displayed.
3 . Use ▲AIR or SHIFT ▼ (PANIC) to display the desired setting.
4 . Press and release POWER/ENTER to save the setting. The instrument
will return to the BUMP SETTING screen.
Updating the Bump Interval
This setting defines the amount of time between bump tests. The time can be
set in 1 day increments. The minimum setting is 0 days and the maximum
setting is 30 days. The factory setting is 30 days.
1 . From the BUMP SETTING screen, place the cursor next to BUMP
INTERVAL.
2 . Press and release POWER/ENTER. The current Bump Interval setting
will be displayed.
To Next Page
Loading...
Need help?
General
