GX-6000 Operator’s Manual Start Up • 20
1 . Connect the tapered rubber nozzle or the sample hose and probe to the
GX-6000’s quick connect inlet fitting.
2 . Press and briefly hold down the POWER/ENTER button. Release the
button when you hear a beep.
3 . If LUNCH BREAK is turned on (see “Updating the Lunch Break
Setting” on page 161), the Lunch Break Screen appears. The unit counts
down from 5 seconds at the top of the screen.
• To continue accumulating peak and time-weighted average (TWA)
readings from the last time the GX-6000 was used, press and release
the POWER/ENTER button before the countdown reaches 0 or allow
the countdown to reach 0. If you do not press the POWER/ENTER
button within the 5 second countdown, the GX-6000 automatically
resumes accumulating the peak and TWA readings. The GX-6000
will also continue to keep track of operating time including the
operating time from the last time the GX-6000 was used. See “Time
in Operation Screen” on page 51 for more information about how the
GX-6000 tracks the operating time. The short-term exposure limit
(STEL) reading is reset each time the GX-6000 is turned on.
• To reset the accumulation of these measurements, press and release
the DISP/LOCK button before the countdown reaches 0.
4:07
LUNCH BREAK
5 SEC
YES:ENTER
NO:DISP
To Next Page
Loading...
Need help?
General
