Roche Diagnostics
352 Instructions for Use · Version 13.0
Index cobas b 123 POC system
Perfomance data
– Measurement parameters, 55
Performance data, 55
– Comparison of micro samples to normal samples, 78
– Correlation to other methods, 74
– Linearity
– Micro sample mode, 73
– Normal sample mode, 72
– Precision
– Micro sample mode, 66
– Normal sample mode, 55
Plausibility check for neonatal bilirubin measurements,
152
PO2 calibration, 225
Power cable, 34
Power supply, 34
Preanalytics, 139
– Dialysis Solution, 144
– Sample collection, 139
– Sample collection containers, 141
– Sample handling, 143
Precision
– Micro sample mode, 66
– Normal sample mode, 55
Printer, 32
– Change printer paper, 306
– Specifications, 88
Product data, 86
– Acoustic noise level, 86
– Classifications, 86
– Dimensions, 86
– Electrical data, 86
– Weight, 86
Product names, 7
Proficiency test, 194
– Proficiency test measurements, 195
Publication information, 2
– Approvals, 3
– Contact addresses, 4
– Copyright, 3
– Edition notice, 2
– Feedback, 3
– License information, 3
– Open source and commercial software, 3
– Revision history, 2
– Screenshots, 2
– Trademarks, 3
– Training, 2
– Warranty, 3
Put out of operation, 134
– For less than 24 hours, 134
– For more than 24 hours, 134
– Procedure, 135
Q
QC database, 192
QC results and reports, 191
– QC values tab, 191
QC scheduler, 199
QC troubleshooting, 218
QC troubleshooting for parameters, 324
Quality control, 179
– AutoQC measurements, 184
– Configuring QC rules and consequences, 207
– Configuring QC settings, 209
– Configuring the QC scheduler, 199
– Defining and configuring QC materials, 203
– Evaluating QC measurement results, 211
– General QC concept, 181
– Important information for evaluating QC results, 183
– Levey-Jennings graphs, 193
– Manual QC measurements, 185
– Multirules, 211
– QC database, 192
– QC materials
– Specifications, 85
– QC results and reports, 191
– QC troubleshooting, 218
– Removing QC consequences, 215
– Troubleshooting AutoQC module blockages, 219
– User-activated AutoQC measurements, 184
R
Recalibration, 226
Reference and critical ranges
– Assigning a correlation factor to a parameter, 122
– Assigning reference and critical ranges, 118
– Critical ranges, 117
– Monitoring reference and critical ranges on
measurement reports, 121
– Reference/normal ranges, 115
Reference and critical values, 115
Removing QC consequences, 215
Roche MICROSAMPLER PROTECT, 142
RS 232 interface assignment, 35
S
Safety information, 15
– Safety classifications, 17
– Safety labels on the instrument and consumables, 26
– Safety precautions, 18
– Biohazardous materials, 20
– Electrical safety, 20
– Incorrect results, 23
– Installation and deinstallation, 19
– Instrument damage, 25
To Next Page
Loading...
