List and Sweep Mode
R&S
®
SMA100B
172User Manual 1178.3834.02 ─ 05
Remote command:
[:SOURce<hw>]:LFOutput:FREQuency:MODE on page 603
Current Frequency
In "RF/LF Frequency Sweep" mode, displays the current frequency.
In Mode = "Step", the parameter is editable and you can enter the next frequency step.
Remote command:
[:SOURce<hw>]:FREQuency:MANual on page 593
[:SOURce<hw>]:LFOutput:FREQuency:MANual on page 603
Current Level
Applies to "RF Level Sweep" mode.
Displays the current level value.
In Mode = "Step", the parameter is editable and you can enter the next level step.
Remote command:
[:SOURce<hw>]:POWer:MANual on page 632
Mode
Selects the sweep mode.
For detailed information on the sweep modes and the triggering, see Chapter 6.1, "Sig-
nal Generation and Triggering in the Sweep and List Modes", on page 156.
"Auto"
Generates a continuously repeating sweep signal directly after acti-
vating the sweep mode.
The sweep steps are performed automatically, controlled by the dwell
time.
"Single / Extern Single"
Generates a single sweep cycle after a trigger event.
The sweep steps within the cycle are performed automatically, con-
trolled by the dwell time. If one cycle is completed, the instrument
waits for the next trigger event.
"Step / Extern Step"
Generates the sweep signal step-by-step, manually triggered.
"Extern Start/Stop"
Generates a continuously repeating sweep signal that is started,
stopped, and restarted by subsequent external trigger events.
The sweep steps are performed automatically, controlled by the dwell
time.
Remote command:
[:SOURce<hw>]:SWEep[:FREQuency]:MODE on page 648
[:SOURce<hw>]:SWEep:POWer:MODE on page 646
[:SOURce<hw>]:LFOutput:SWEep[:FREQuency]:MODE on page 609
:TRIGger<hw>[:SWEep]:SOURce on page 683
:TRIGger<hw>:FSWeep:SOURce on page 683
:TRIGger<hw>:PSWeep:SOURce on page 683
:TRIGger<hw>:LFFSweep:SOURce on page 683
Sweep Mode Settings
To Next Page
Loading...
