Rohde & Schwarz SMAB-B92 - Page 593

Remote Control Commands
R&S
®
SMA100B
591User Manual 1178.3834.02 ─ 05
Example: Setting a phase continuous frequency range
SOURce1:FREQuency:CW 502000000
SOURce1:FREQuency:PHASE:MODE NARR
SOURce1:FREQuency:PHASe:CONTinuous:STATe 1
******************************************
// Query the frequency range
SOURce1:FREQuency:PHASe:CONTinuous:LOW?
// Response: 494062500
SOURce1:FREQuency:PHASe:CONTinuous:HIGh?
// Response: 503750000
******************************************
// Vary the frequency. Within the specified range the signal is phase continuous.
SOURce1:FREQuency:CW 49900000
SOURce1:FREQuency:CW 50000000
SOURce1:FREQuency:CW 501000000
SOURce1:FREQuency:CW 503000000
[:SOURce<hw>]:FREQuency:MODE................................................................................591
[:SOURce<hw>]:FREQuency[:CW|FIXed].........................................................................592
[:SOURce<hw>]:FREQuency[:CW|FIXed]:RCL................................................................. 593
[:SOURce<hw>]:FREQuency:MANual..............................................................................593
[:SOURce<hw>]:FREQuency:MULTiplier.......................................................................... 594
[:SOURce<hw>]:FREQuency:OFFSet.............................................................................. 594
[:SOURce<hw>]:FREQuency:CENTer.............................................................................. 594
[:SOURce<hw>]:FREQuency:SPAN.................................................................................595
[:SOURce<hw>]:FREQuency:STARt................................................................................ 595
[:SOURce<hw>]:FREQuency:STOP.................................................................................595
[:SOURce<hw>]:FREQuency:STEP:MODE...................................................................... 596
[:SOURce<hw>]:FREQuency:STEP[:INCRement]............................................................. 596
[:SOURce<hw>]:FREQuency:PLL:MODE.........................................................................597
[:SOURce<hw>]:FREQuency:PHASe:CONTinuous:HIGH?................................................ 597
[:SOURce<hw>]:FREQuency:PHASe:CONTinuous:LOW?................................................. 597
[:SOURce<hw>]:FREQuency:PHASe:CONTinuous:MODE.................................................597
[:SOURce<hw>]:FREQuency:PHASe:CONTinuous:STATe................................................. 598
[:SOURce<hw>]:FREQuency:MODE <Mode>
Sets the frequency mode for generating the RF output signal. The selected mode
determines the parameters to be used for further frequency settings.
Parameters:
<Mode> CW | FIXed | SWEep | LIST
CW|FIXed
Sets the fixed frequency mode. CW and FIXed are synonyms.
The instrument operates at a defined frequency, set with com-
mand [:SOURce<hw>]:FREQuency[:CW|FIXed].
SOURce Subsystem