Schenck process Disomat Opus - Page 142

Event Messages List of Event Messages
Display Text Edit *) Cause Remedy
S1412-2:Foreign Dongle Check number measurement
showed that the serial number
stored in dongle is incorrect.
M1511-1:Communication Error Read error in communication
with Measuring Module 1
M1512-1:Communication Error Read error in communication
with Measuring Module 2
M1511-2:Communication Error Write error in communication
with Measuring Module 1
M1512-2:Communication Error Write error in communication
with Measuring Module 2
M1511-3:Communication Error Scale 1 measuring rate not
converted
Re-acquire
calibration
parameters Part
2.
M1512-3:Communication Error Scale 2 measuring rate not
converted
Re-acquire
calibration
parameters Part
2.
M1511-4:Communication Error Scale 1 switching filter time not
converted
Re-acquire Scale
1 parameters.
M1512-4:Communication Error Scale 2 switching filter time not
converted
Re-acquire Scale
2 parameters.
M1511-5:Communication Error Scale 1 display filter time not
converted
Re-acquire Scale
1 parameters.
M1512-5:Communication Error Scale 2 display filter time not
converted
Re-acquire Scale
2 parameters.
M1511-6:Communication Error Scale 1 default check number
not determined
Recall diagnosis.
M1512-6:Communication Error Scale 2 default check number
not determined
Recall diagnosis.
M1511-7:Communication Error Scale 1 sensitivity not
determined
Recall diagnosis.
M1512-7:Communication Error Scale 2 sensitivity not
determined
Recall diagnosis.
M1511-9:Communication Error Scale 1 filter data not active Re-acquire data.
M1512-9:Communication Error Scale 2 filter data not active Re-acquire data.
M1520-1:Communication Error Fieldbus: unknown Write ID
M1520-2:Communication Error Fieldbus: inknown Read ID
W1611:Write Error Write operation into dongle or
measuring module 1
incomplete
Check settings.
W1612:Write Error Check settings. Write operation into dongle or
measuring module 2
incomplete
W1711-1:Write Error Write operation into dongle 1
incomplete
Re-plug dongle.
W1712-1:Write Error Write operation into dongle 2
incomplete
Re-plug dongle.
W1711-2:Write Error Write operation into dongle 1
faulty
Repeat last
editing.
W1712-2:Write Error Write operation into dongle 2
faulty
Repeat last
editing.
W1711-3:Write Error Write operation into dongle 1
faulty
Dongle code 1
cannot be
written.
W1712-3:Write Error Write operation into dongle 2
faulty
Dongle code 2
cannot be
written.
W1711-4:Write Error Write operation into dongle 1
faulty
Dongle 1: write
access
incomplete
BV-H2313 GB 0630 DISOMAT
®
Opus – Operating Manual
- 136 - © Schenck Process GmbH, Darmstadt