Schenck process Disomat Opus User Manual

Event Messages List of Event Messages
Display Text Edit *) Cause Remedy
W7003-7:EDP Error * Cyclic message transmission
timeout
W7003-8:EDP Error * Cyclic transmission, no timer
W7003-nnn:EDP Error **) * Internal error in sending
response message
M7501:DISONET faulty DISONET Slave: connection to
Master
M7501-N:DISONET faulty DISONET Master: connection
to Slave N
M7513-nnn:DISONET faulty**) * MULTIRAIL transmission error:
Slave twin-unit weight
A7801:DISONET faulty DISOBOX: DISONET Slave:
connection to Master
A7813-nnn:DISONET faulty**) * MULTIRAIL transmission error:
zero value to twin-unit slave
A8916-FFLLLLLEE:Run-time error in SMALL foreground process:
file FF, line LLLLL, error EE
Edit calibration
parameters or
plug appropriate
dongles.
A8917-FFLLLLLEE:Run-time error in SMALL background process:
file FF, line LLLLL, error EE
Edit calibration
parameters or
plug appropriate
dongles.
A9013-nnn:Parameter error **) The twin-unit calibration
parameters stored in dongle
are different
Edit calibration
parameters or
plug appropriate
dongle
s
A9213-nnn:Parameter error **) MULTIRAIL: big twin-unit scale
calibration parameters
Edit calibration
parameters or
plug appropriate
dongles.
M9113-nnn:No data comparison at the time being **) Twin-unit calibration
parameters in dongles cannot
be compared at the time being.
Figures not read out yet
Repeat at a later
time
S9309:Battery voltage, defaults activated Ex-variant: battery voltage too
low after longer cut-off.
Parameter default values
activated.
Re-acquire
parameters.
A9411-nnn:Parameter error **) Data cannot be stored in
dongle
Exchange dongle
A9511-nnn:Deadload Error **) Acquire Scale 1 deadload Check dead load
or exchange
converter card.
A9512-nnn:Deadload Error **) Acquire Scale 2 deadload Check dead load
or exchange
converter card.
A9611-nnn:Parameter Error **) Read Scale 1 calibration
parameters
A9612-nnn:Parameter Error **) Read Scale 2 calibration
parameters
A9613-nnn:Parameter Error **) Read Twin-unit calibration
parameters
A9614-4:Parameter Error Read data record in SMALL
A9711-nnn:Parameter Error **) Write Scale 1 calibration
parameters
A9712-nnn:Parameter Error **) Write Scale 2 calibration
parameters
A9713-nnn:Parameter Error **) Read Twin-unit calibration
parameters
A9714-1:Parameter Error Write data record in SMALL
A9714-4:Parameter Error Write data record in SMALL
S9811:Parameter Error Measuring module 1 improperly
calibrated
Exchange
measuring
module.
DISOMAT
®
Opus – Operating Manual 0630 BV-H2313 GB
© Schenck Process GmbH, Darmstadt - 139 -

Schenck process Disomat Opus Specifications

General

Brand	Schenck process
Model	Disomat Opus
Category	Control Panel
Language	English