Seca mVSA 535 - Removing;Fitting Probe Holder (Devices with Temperature Probe); Removing the Probe Holder; Fitting the Probe Holder

Hygiene treatment • 105
English
17-10-05-353-002g_10-2020 B
8.4 Removing/fitting probe holder (devices with temperature probe)
WARNING!
Patient hazard
The color of the probe holder indicates whether a device is intended
for oral/axillary or rectal temperature measurement. This distinction
can no longer be made once the probe holder has been removed.
Confusing the probe holders can lead to cross-contamination.
► Ensure that the probe holder is fitted back in the device from which
it was removed following a hygiene treatment.
Removing the probe holder 1. Open the covering cap.
2. Remove the probe holder.
Fitting the probe holder 1. Insert the probe holder in the SmartBucket as shown in the illustration
below.
2. Close the cover cap until you hear it engage.
Press!
Click!