Seca mVSA 535 - Making Presets for Vital Signs Measurement; Presets for Blood Pressure

148 • secamVSA 535/seca mBCA 525
17-10-05-353-002g_10-2020 B
3.6 Making presets for vital signs measurement
In the Settings tab, you can set up the settings for blood pressure,
temperature and SpO
2
measurements preferred in your institution.
The user can modify the settings during a measurement procedure
➔ Measuring vital signs. The presets will be active again after the end of the
measurement procedure.
For the Vital signs tab, you can select a color mode to enable the device to be
read perfectly whatever the illumination conditions. This function is not avail-
able for other tabs. This setting cannot be changed during a measurement
procedure.
Presets for blood pressure
NOTE
This is where to specify default settings which the user can modify for
the respective current measurement procedure. The settings from the
default settings then become active again.
Making general settings
1. Press the Settings tab.
➔ Presets for blood pressure
➔ Presets for pulse rate (seca measuring equipment only)
➔ Presets for SpO
2
➔ Presets for temperature (COVIDIEN
TM
FILAC
TM
3000 only)
➔ Selecting color mode for Vital signs tab
➔ Making general settings
➔ Configuring multiple measurement