Seca mVSA 535 - Setting up Device; Connecting the Smartbucket

Starting up the device • 33
English
17-10-05-353-002g_10-2020 B
5.2 Setting up device
NOTE
This section shows how to assemble all of the measuring accessories
available for this device. The actual scope of delivery of your device
may be less than this.
NOTICE!
Damage to device, malfunction
Excessive use of force may damage tubes and cables.
► In order to connect measuring accessories to the device or remove
them from it, take hold of tubes only by the tube coupling.
► In order to connect measuring accessories to the device or remove
them from it, take hold of cables only by the connectors.
► Use only measuring accessories which have no externally visible
damage.
Connecting the SmartBucket NOTICE!
Malfunction
The SmartBucket needs one of the USB interfaces for communication
and power supply. If the USB connection is removed, no vital signs
can be measured.
► Always keep the SmartBucket connected to the USB interface.
► Only connect accessories, for example a USB memory stick, to the
other USB interface.
► Connect the USB cable of the SmartBucket to a free USB interface of the
monitor.
h
COVIDIEN
TM
FILAC
TM
3000 temperature probe
1
i
Push-button electrodes for affixing to patient (pack of 100) 1
j
Measuring mat with rechargeable battery and electrode
cables
1
No. Accessory for the version shown Pcs.
➔ Connecting the SmartBucket
➔ Connecting the blood pressure cuff
➔ Connecting the temperature probe
➔ Connecting the in-ear thermometer
➔ Connecting the seca SpO
2
sensor
➔ Connecting the Masimo SET
®
SpO
2
sensor
➔ Suspending the measuring mat in the magnetic catch