38 • secamVSA 535/seca mBCA 525
17-10-05-353-002g_10-2020 B
5.3 Establishing a power supply
1. Plug the device connector of the power supply cable into the connecting
socket of the device.
2. Plug the power supply connector into a power supply socket.
5.4 Charging rechargeable batteries
Before you start up the device for the first time, the rechargeable batteries for
the monitor and the measuring mat – if the measuring mat is present– must
be fully charged.
1. Ensure that the measuring mat – if the measuring mat is present– is cor-
rectly suspended in the magnetic catch of the monitor ➔ Suspending the
measuring mat in the magnetic catch.
2. Connect the device to the power supply ➔ Establishing a power supply.
3. Press the ON/OFF button of the monitor.
The LED of the ON/OFF button is white.
The charging process starts.
Current charge status is displayed for approx. 15 seconds:
After approx. 5 minutes, the device switches to standby.
The screen goes off.
The LED of the ON/OFF button flashes green.
When the rechargeable batteries are fully charged, the device switches
off.
The LED of the ON/OFF button goes off.
NOTE
Leave the device connected to the power supply for approx. 4 hours
when starting it up for the first time. This ensures that the recharge-
able batteries for the monitor and the measuring mat are fully charged.
To Next Page
Loading...
