Seca mVSA 535 - Setting the Date and Time

Starting up the device • 39
English
17-10-05-353-002g_10-2020 B
5.5 Setting the date and time
When you start up the device for the first time, you first need to set date and
time.
1. Ensure that the measuring mat – if the measuring mat is present– is cor-
rectly suspended in the magnetic catch of the monitor ➔ Suspending the
measuring mat in the magnetic catch.
2. Connect the device to the power supply.
3. Press the ON/OFF button of the monitor.
The LED of the button is white.
The initial start screen appears.
4. Enter the current date:
a) Press the input field
b) Use the keypad : Enter current date
c) Press the button: Confirm entry
5. Enter the current time:
a)
Press the input field
b) Use the keypad : Enter current time
c) Press the button: Confirm entry
6. Press the button.
7. Continue operating the device – you have the following options:
► Leave device switched on (recommended): ➔ Charging
rechargeable batteries
► Perform measurements using the power supply: ➔ Operation
► Configure device using the power supply: ➔ For administrators:
Configuring seca mVSA 535 /seca mBCA 525