Seca mVSA 535 - Updating the Measuring Mat Software

Managing system components • 159
English
17-10-05-353-002g_10-2020 B
NOTE
The software package for the monitor also contains data for the mea-
suring mat. If this data is more current than the software on the mea-
suring mat, the corresponding message will appear on screen. Then
proceed as described in the section entitled ➔ Updating the measur-
ing mat software.
4.3 Updating the measuring mat software
In the following cases, it may be necessary to update the software of the
measuring mat:
• Monitor software has been updated (
secamVSA 535,
seca mBCA 525)
➔ Updating the monitor software
• System has had a measuring mat added (
secamVSA 535)
➔ Retrofitting the measuring mat (secamVSA 535 only)
• Measuring mat has been replaced with a new one (
secamVSA 535,
seca mBCA 525)
If the measuring mat software is out of date, the corresponding message will
appear on the monitor. In this case, proceed as outlined below:
1. Press the System tab.
2. Press the Measuring mat button.
3. Press the Software update Measuring mat button.
4. Follow the on-screen instructions.
5. Press the Start software update button.
The software update will be installed.