Seca mVSA 535 - Receiving Weight and Height (Seca 360° Proximity)

Operation • 81
English
17-10-05-353-002g_10-2020 B
Receiving weight and height
(
seca 360° proximity)
If a corresponding network connection is set up, weight and height can be
submitted from a seca measuring device via LAN or WiFi.
1. If you have not yet done so, call up a patient file: ➔ Calling up a
seca patient file.
The measuring device preset by your administrator is reserved
automatically.
The Workflow LED on the preset measuring device is green.
2. Measure the patient as described in the instructions for use for the
measuring device.
3. Submit the measured values as described in the instructions for use for
the measuring device.
The values appear on the
secamVSA 535/seca mBCA 525 in the Weight
and Height fields (in this case: Vital signs tab):
You have the following options for continuing:
► Measure more vital signs ➔ Measuring vital signs
► Measure bioimpedance ➔ Measuring bioimpedance
► Stop the measurement procedure ➔ Stopping a measurement
procedure
Beispiel-Darstellung:
Messstation seca 285 mit Interface-Modul seca 452 und seca mVSA 535
2. Messen
3. Senden
LAN/WiFi
Empfangen
1. Messgerät wird reserviert
LED-Messvorgang
1. Measuring device is reserved
2. Measure
3. Submit
Receive
Example display:
seca 285 measuring station with seca 452 interface module and
seca mVSA 535
Workflow LED