Seca mVSA 535 - Page 188

188 • secamVSA 535/seca mBCA 525
17-10-05-353-002g_10-2020 B
4. Press the button.
The seca connect 103: Workflow page is displayed.
5. Specify the settings for the scan sequence for user and patient ID:
► Sequence for ID scan fixed: 1. User, 2. Patient
► Sequence for ID scan flexible
6. Specify whether measurements are to be possible even if the connection
to the EMR system is interrupted (offline measurements):
► Do not allow offline measurement
► Allow offline measurements
NOTE
Offline measurements are temporarily saved in the Unsubmitted
measurements list. When the connection to the EMR system is
active again, the measurements can be called up, evaluated and sub-
mitted to the EMR system ➔ Using the Unsubmitted measurements
list.
7. Under User-ID, specify whether a password is required for login:
► Password must be entered (recommended)
► No password required
8. If desired, enter an Organization ID to assign the device to a department
in your institution, for example.
9. Adopt the settings:
a) Press the button
b) Press the button
The settings are saved.