Cirklon Sequencer User Manual
included in the name. For example, a P3 pattern may be named “Trk1 P1”, a CK pattern
“Trk1 C1”. If a custom track name has been defined, this will be used in place of the default
“Trkn”.
no pattern after delete - normally after deleting a pattern, the previous pattern will be
assigned to the track. With this option enabled, the track will have no pattern assigned.
show MIDI note numbers - MIDI note values will be shown as numbers, rather than note
names.
aux edit sets flag - when adjusting the numeric value of an aux step in a P3 pattern,
inactive steps will be turned on automatically.
ck edit, auto clear gang - in CK pattern edit, the selection of ganged notes is cleared when
gang mode is turned off.
play fills in edit/record - this option is enabled by default, and causes a track with a fill
pattern assigned to switch to the fill pattern during pattern edit or real-time record. It can be
turned off if this behaviour is not desired, for example during live performance.
select main ptrn on trk chg - if you have selected the fill pattern field, switching to another
track will return the track page selection to the main pattern field
force save menu after edit - this option will cause the pattern SAVE menu to appear
when you exit pattern edit mode after making any changes to a pattern.
always auto-name save-as-new - when saving a pattern as new in pattern edit, an auto-
generated name will be used, and you will not be prompted to confirm it.
full manual bar follow - some pattern edit operations cancel the ‘bar follow’ setting, to
prevent unintended edits of pattern steps as the bar position advances. This option leaves it
up to the user to manually turn off bar follow.
ignore MIDI stop if master - when running from its internal tempo clock, Cirklon will
normally stop in response to an incoming MIDI STOP message. With this option enabled, it
wont.
treat MIDI CONT as START – some PC-based sequencer software sends MIDI continue
messages with song position pointer, instead of MIDI start. Setting this option will allow
Cirklon to slave correctly to such software.
To Next Page
Loading...
